Advantages and Disadvantages of Welded Flange Valves
I. Advantages
Excellent rigidity of the connection structure and high sealing reliability
The pipe and valve flanges are integrated and rigidly connected through welding, without thread clearance, and there are no problems such as thread slippage, loosening, and leakage. The gasket at the flange end surface independently bears the medium seal, has strong resistance to pressure difference and medium erosion, and the leakage risk during long-term operation is much lower than that of threaded connection valves.
Suitable for harsh conditions and wide range of medium applications
It can withstand high temperatures, high pressures, strong vibrations, flammable and explosive, corrosive media conditions, and is widely used in thermal power, chemical, oil and gas, and industrial main process pipelines. The pipe diameter covers DN15 and above full specifications, and large-diameter main pipelines are preferred. The pressure-bearing and temperature tolerance upper limit is higher than that of threaded and threaded flange valves.
Strong resistance to pipeline deformation and external force disturbance
The welded joint eliminates the moving parts of the pipe and valve connection, can counteract the stress caused by pipe thermal expansion and contraction, foundation settlement, and fluid impact, and is less likely to cause interface loosening in pipeline vibration environments, ensuring long-term operational stability.
Long service life and low maintenance frequency
The welded joint has no easily worn threaded parts. Under normal conditions, the weld seam life matches the pipe material and valve body, and there is no need for regular interface tightening; only regular inspection of the flange gasket is required, significantly reducing the workload of interface leakage repair.
High pressure rating upper limit
It can match high-pressure pipeline standards and meet the design requirements of industrial high-pressure process systems. It is the standard connection type for high-pressure process pipelines.
II. Disadvantages
Irreversible disassembly and maintenance cost is high
The pipe and flange are a permanent welded structure. When replacing valves or renovating pipelines, the pipe must be cut to remove the valve; after replacement, the pipe opening needs to be re-processed, welded, and the parallelism of the flange needs to be corrected. The process is complicated, and the maintenance period is long.
Construction conditions are limited and there is a risk of fire operations
The entire installation and renovation process is a fire welding operation. In flammable and explosive medium plants, enclosed spaces, and prohibited fire areas, construction requires obtaining fire approval, and additional fire prevention, ventilation, and explosion-proof safety measures need to be implemented. The pre-construction process is cumbersome.
High technical requirements for construction and strict acceptance standards
The pipe end requires standardized beveling processing and assembly welding. The weld seam is prone to defects such as pores, slag inclusions, and incomplete penetration; pressure pipeline systems need to conduct additional weld flawless detection. The requirements for welder qualifications and on-site quality inspection are higher, and the labor and testing costs increase.
Poor flexibility for on-site adjustment and alignment
The relative position of the pipe and valve after welding is fixed. During the installation stage, the alignment accuracy and parallelism of the flange are difficult to correct. After welding, it is impossible to adjust the length of the pipeline or the installation angle of the valve. The pre-assembly and positioning accuracy requirements are extremely high.
Difficult to expand and modify
When the pipeline needs to be re-routed or additional branches are added later, the original welded pipe sections cannot be reused. Most of them require cutting and re-preparation welding. Compared with threaded connection valves, the renovation loss is greater.